Ric Fauset, Owner/Engine Builder
Looking for a good deal? Then you have come to the right place. These items still have lots of life; they just need to find the right home.
Check it out!
Set of 8 TRW PowerForge Pistons 4.125 Bore for SBC Part no. L2311
$100.00 
8 INCH
4500 STALL
TURBO SPLINE
GM CONVENTOR
$500
Top End Kit
Wiseco
Hi-Performance
Part no. PK1441 - '01-07 Hon TRX250EX 10.5:1CR 69.5mm
This part is NEW. It wouldn't work for what I needed it for. Kit comes with the pin and gaskets.
$100.00
Powermaster Alternator for your racecar. 100 amp low mount for a SBC. Part # 8-898
Brand new, never bolted on, It just won't work on my car.
$299.00
SBC 355 Fresh, ran 8.92 in a Super Comp Dragster. Shaft rockers, All Isky-650 solid roller with rev kit. 220 AFR heads, 6 inch rods, Comp built drive. This deep oil pan has an 8 quart capacity. What works best for you? We will sell this engine with or without the tunnel ram or single plane manifold. Call with questions... No, it doesn't come with the coolers or the dryer...
CAM Shaft Comp Cam SBC Hydraulic Roller
Part no. 12-416-8
Adv. Dur. 264 270
Lobe Sep: 112 degrees
Valve lift: 212 218
This cam was run in SBC on a Dyno for about 20 mins. The customer decided he wanted more UMPF so we changed out the cam.
$200.00
CP Pistons Lateral Gas Ported for BBC
4.600 bore
compression height 1.120
no pins or clips
have been messaged, brand new, still in box
Part Number SS5404
Cam Profile CP834
Spec sheet included.
$750.00
